Below is a clear, step-by-step guide to help you install your side body skirts safely and correctly. Please read through all instructions before starting.

PDF Side Skirt Installation

Step 1: Gather Your Tools and Materials

• Included: Self-tapping screws, double-sided mounting tape
• Recommended: Adhesion promoter, electric drill, drill bits, clean cloth, mild cleaning solution or isopropyl alcohol, masking tape (optional)
• Note: Two-person installation is recommended for safety and accuracy.

Step 2: Prepare the Vehicle

• Park on a level surface and engage the parking brake.
• Raise the vehicle with a jack or lift for easier access.

Step 3: Clean the Rocker Panels

• Use a mild cleaning solution or isopropyl alcohol to remove all dirt and residue.
• Ensure the surface is completely dry before moving on.

Step 4: Test-Fit the Side Skirts

• Hold each side skirt against the rocker panel to check alignment.
• Make any necessary adjustments to ensure a proper fit.

Step 5: Apply Adhesion Promoter

• Lightly coat the areas on the side skirt where the double-sided tape will be placed.
• Use sparingly to avoid damaging the paint.

Step 6: Attach the Double-Sided Mounting Tape

• Cut the tape to the needed lengths.
• Press it firmly onto the prepared areas on the back of the side skirt.
• Keep the tape backing on until you are ready to secure the skirt to the vehicle.

Step 7: Position and Align the Side Skirts

• Carefully align the side skirt with the rocker panel.
• Check alignment from front to back and top to bottom before securing.

Step 8: Secure the Tape

• Peel away a small portion of the tape backing.
• Press the exposed tape firmly against the rocker panel.
• Continue peeling and pressing until the entire length is secured.

Step 9: (Optional) Apply Adhesion Promoter to the Car

• For an even stronger bond, apply a thin layer of adhesion promoter to the rocker panel itself.
• Use a minimal amount.

Step 10: Drill and Install Self-Tapping Screws

• Pre-drill pilot holes if needed, then insert the self-tapping screws.
• Space them evenly along the underside of the skirt.
• Avoid overtightening to prevent damage.

Perform a Final Inspection

• Check that the side skirt sits flush against the rocker panel.
• Press along the taped areas if you notice any gaps.

Post-Installation Guidelines

• Do not wash the car or drive at high speeds for 24 hours to allow the adhesive to cure.
• Be careful when entering or exiting the vehicle—avoid stepping on the side skirts.

Congratulations! Your side skirts are now installed. By following these guidelines, you’ll ensure a secure, long-lasting upgrade that enhances both the look and performance of your vehicle. If you have any questions or concerns, feel free to reach out to our support team.