Rear Window Spoiler Installation Guide
What You’ll Need
- Clean cloth
- Soap & water (or alcohol wipes)
- Heat gun or hair dryer (optional, for cold weather)
Step 1: Clean the Area
-
Wash and dry the top edge of your rear window and roofline.
-
Wipe with alcohol to remove any dirt, dust, or wax.
Step 2: Test Fit
-
Hold the visor spoiler in place to see how it sits.
-
Use masking tape if you’d like to mark the correct position.
Step 3: Peel & Stick
-
Gently peel a few inches of the tape backing from each end.
-
Position the spoiler carefully, then stick the ends down.
-
Pull the rest of the tape backing out while pressing along the visor.
Step 4: Secure
-
Press firmly along the entire spoiler to lock it in place.
-
In cold weather, warm the tape with a hair dryer or heat gun on low for best adhesion.
-
Don’t wash the car or expose it to rain for 48 hours.
