Front Lip Installation Guide

Scissors: Used to cut 3M tape slices for easier application.
1-inch wide 3M tape: Helps hold the front lip in place before securing it with screws.
Note: Two-person installation is recommended for safety and accuracy.

Assemble the Front Lip if it's 3 pieces: Use the provided screws to securely connect all three pieces of the front lip together.
Prepare the Bumper Clips: Locate the two self-tapping clips under the bumper and unclip them. - These clips will be reinserted later, but this time they will go through both the bumper and the front lip for a flush and secure fitment.
Test Fit the Front Lip: Hold the assembled front lip against the front bumper to determine the best alignment.
Apply 3M Tape for Extra Security: Once you have an idea of the screw placement, apply 3M tape between those contact points on the front lip.
Clean the Installation Area: Use a clean microfiber cloth and rubbing alcohol or a mild cleaner to thoroughly clean the surface of the bumper where the front lip will be installed.

Hold the Front Lip in Position: Ask a friend or two to help hold the front lip against the bumper in the correct position.
Secure with Screws: Using a drill or screwdriver, insert screws through the designated holes in the front lip and into the bumper. - Be sure to space out the screws evenly for a balanced and firm attachment.
Reinsert the Bumper Clips: The two bumper clips removed earlier must now be reinserted through the front lip and into the bumper.
Press Along 3M Tape Areas: Firmly press along the areas where the 3M tape was applied.

Double-check that the front lip sits flush and securely attached to the bumper.
Press along all taped areas to ensure proper adhesion.
Inspect the screws and ensure they are properly tightened without over tightening, which could cause damage.

Do not wash the car or drive at high speeds for 24 hours to allow the adhesive to fully cure.
Periodically check the screws and tape to ensure the front lip remains secure over time.